CO2 foaming dedicated CO2 pressurization system

Introduction to CO2 Boosting System for Carbon Dioxide Foaming

Carbon dioxide, as a component of air, can be produced from liquid air or as a byproduct of building materials and food industries. It is inexpensive and harmless to the atmospheric ozone layer, with a high mass molar ratio and high foaming ratio. Used to replace auxiliary foaming agents such as chlorofluorocarbons, it not only has good environmental benefits, but also considerable economic benefits. So let me introduce the important role of carbon dioxide booster pump in foaming process.

The carbon dioxide booster pump can increase the pressure required by the low-temperature liquid carbon dioxide booster extruder. Different pneumatic CO2 booster pumps can be used to match different models.

The Fuente brand CO2 foaming dedicated CO2 pressurization system uses a low-temperature high flow gas driven booster pump ZTD15-2F

General appearance of CO2 foaming dedicated pressurization system

Introduction to Parameters of Carbon Dioxide Foam Injection System

Model: ZTS-ZTD15-CO2 (all internal pipe fittings and buffer devices are insulated as shown in the above figure)

Boosting medium: liquid CO2, or CO2 containing a small amount of gas

Buffer low-temperature tank: 10-20L

Pipeline: 304 stainless steel pipe, pressure resistance value 40Mpa

Connection method: card sleeve type link

Low temperature CO2 low inlet pressure range: ≥ 5.8 bar

Drive pressure range: 2-8 bar

Output pressure range: 2bar -130bar

Output flow rate: 120kg-150kg/H

Control accuracy: ± 2%

Equipment gas consumption: 1m ³/min

Output interface: G1/2 or NPT1/2 internal thread connection

Pressurized gas inlet: G1/2 or NPT1/2

Drive air connector: 12mm quick connector

Equipment size approximately: 1200 * 800 * 750 (mm) in accordance with ergonomic design