Mobile phone: 18815239758 (same as WeChat)
Phone: 0576-89881178
Phone: 0576-89825885
Introduction to Feinte ZTA series pneumatic gas booster pump
The Feentor ZTA series pneumatic gas booster pump adopts a single gas controlled unbalanced gas distribution valve to achieve the reciprocating motion of the pump. It is a piston type booster pump, and the pump body is made of aluminum alloy and stainless steel. Some materials are oxidized to ensure the durability of the pump. All seals are imported high-quality products, and the maximum design driving pressure is 10 bar. To ensure the service life of the pump, it is recommended that the driving pressure be ≤ 8 bar. The drive piston diameter of this series of pumps is 160mm, which is a single acting pump. All single acting pump heads are equipped with exhaust cooling. Except for ZTA02/ZTA05/ZTA08
The following is a schematic diagram of the ZTA series pneumatic booster pump
PL=driving air pressure PA=input air pressure PB=output air pressure
The parameters and models of the ZTA series pneumatic gas booster pump are as follows
Notes:
The pressurized medium should be clean and free of impurities. By adjusting the driving pressure, the output pressure can be adjusted as much as possible, and the output pressure is proportional to the driving pressure. In addition, when choosing the ZTA series pneumatic booster pump, it is important to pay attention to the inlet pressure range and flow rate selection of the pump.
Fax: 0576-89888385
Address:4th Floor, Building 2, No. 78 Huibin Road, Xinqian Street, Huangyan District, Taizhou City, Zhejiang Province
Email: vic@tz-fet.com
