How to choose a pneumatic liquid booster pump

Technical support inquiry / 2026-08-19 09:45:13 气动液体增压泵气液增压泵

How to choose a pneumatic liquid booster pump By posing a few questions that match each other, everyone can choose what type of booster pump to use Suitable for use in one's own place.

1: What liquid is being pressurized Is it corrosive? (Pneumatic liquid booster pump is sealed by a sealing ring. The area ratio of the large and small pistons is used for boosting. The corrosive liquid can damage the sealing ring and is not recommended for use.)

2: What is the viscosity of the pressurized liquid? (Pneumatic liquid booster pump is a piston pump that moves back and forth to suck in liquid. If the viscosity is too high, the fluidity will be small, which can easily lead to insufficient suction. It is not recommended to use it.)

3: Pressurized liquid How much MPA should be increased in pressure? How much stable pressure can the air compressor provide? Pneumatic liquid booster pump is pressurized by the ratio of small and large pistons, such as a 10:1 ratio of small and large pistons and a gas source of 0.6MPa. So after pressurization, it will be 6MPa)

4: What are the requirements for traffic? (Pneumatic liquid booster pump drive cylinder is divided into 160mm-120mm-100mm-80mm-80mm. The larger the cylinder diameter, the greater the flow rate under the same boost ratio.)

5: When choosing a pneumatic liquid booster pump, it is important to leave a margin for the booster pump. For example, using a 6-fold booster pump can just meet your usage requirements You choose 10 times Because there may be fluctuations in the on-site gas source, resulting in pressure not meeting the requirements. When the pressure of the pneumatic liquid booster pump drops, the booster pump will automatically replenish the pressure At this point, you can choose a slightly higher option that can consistently maintain the pressure you need.