When the compressed air booster pump is used for local boosting services in your factory workshop, it also needs maintenance and upkeep. Below are several phenomena and solutions that occur when the pump is used for a long time
Problem 1: A customer reported that the compressed air booster pump suddenly noticed an increase in working speed and a slow rise in pressure after working for a period of time.
Option 1: Check whether the devices on both sides of the pump have missing sealing rings, or if the springs are corroded (due to high moisture content), or if the sealing rings of the valve core are worn or detached. Regarding this issue, it is important to note that there should not be too much moisture or impurities present on site.
Problem 2: During the operation of the booster pump, there is severe icing on the ventilation pipe and muffler,
Option 2: It is recommended to work for 2-4 hours and take a short break of 30 minutes for the booster pump. It is suggested to add an oil-water separator to filter the water and lubricate the directional valve with special turbine oil for the three-way combination. If the booster pump is not pressurized, it is recommended to check whether there is water vapor frosting on the one-way valve.
Question 3: What size of air storage tank is suitable for the purchased compressed air booster pump?
Option 3: Configure according to the output flow rate of the booster pump. If the output flow rate of the pump is large, try to configure the gas storage tank slightly larger, and always consider the instantaneous gas consumption of the gas consuming equipment.
The above are the problems that Feentor will encounter during the use of compressed air booster pumps. Hope it can help everyone click on: compressed air booster pump video
Legal statement: The above content belongs to the copyright of Taizhou Feentor - Plagiarism will be prosecuted