You need to understand the "knowledge points" of small gas booster pumps

With the rapid development of industry in today's society, the pressure of gas used in factories or laboratories is increasing. Correspondingly, a gas booster pump was born, which initially had a relatively large volume and high energy consumption. With the advancement of technology, gas booster pump technology is becoming increasingly mature. Taizhou Feentor Fluid Control Co., Ltd. has developed and produced micro and small gas booster pumps for machinery or laboratories with relatively small spaces, solving the problem of insufficient air pressure for many customers due to limited space.

Parameters of small gas booster pump:

Boosting medium: various non corrosive clean gases.

High boost pressure: 80MPA.

Single unit high flow rate: 1200L/min (multiple units can also be connected in parallel for higher flow rate).

Large gas consumption per unit: 900L/min.

Drive pressure requirement: 2-8 bar (6-8 bar is preferred for driving).

Structure and material of small gas booster pump:

The small gas booster pump is generally divided into a booster part, a drive part, and a control part. The boosting components generally include cast steel front and rear boosting end caps, 304 outer cast steel inside the double-layer boosting cylinder barrel, and a set of one-way valves with sealing gaskets Spring. Steel ball The pressure boosting part is composed of the inner and outer shells of the one-way valve, U-shaped cooling pipes made of aluminum alloy, and a series of components such as the pressure boosting piston and piston rod sealing ring. The driving part roughly consists of cast steel front and rear end caps, aluminum alloy drive cylinder barrel, 304 steel and sealing rings for front and rear impact pins (to assist in reversing the control part), 304 material for high and low pressure ventilation steel pipes, and a series of components such as drive pistons and piston rod sealing rings. The control part roughly consists of a cast steel drive chamber, and the directional valve is divided into an outer valve sleeve and an inner valve core composed of aluminum alloy and sealing rings.

Due to different boost ratios and flow rates, there are also many corresponding product models for Fuente small gas booster pumps. Therefore, we will not introduce them to you here. You can visit our website www.tz-fet.com.

Legal statement: The above content belongs to the copyright of Taizhou Feentor - Plagiarism will be prosecuted