Installation and maintenance methods of air booster pump

Many customers do not know the correct installation and maintenance methods for air booster pumps. Now, the editor brings you the correct methods to avoid detours and increase the service life of air booster pumps.   

Precautions for installation:

Firstly, it is important to pay attention to the boost ratio of the air booster pump and select the corresponding high-pressure pipeline and container. The air booster pump can boost the air to 0-800 kilograms. When selecting high-pressure pipelines and containers, the pressure should be higher than that of the air booster pump. The pipeline should be selected with a flow rate greater than that of the air booster pump to prevent a decrease in flow rate. During installation, it is important to ensure that there are no impurities in the pipeline and joints to prevent them from entering the interior of the air booster pump. The air source should be kept clean, and the driving pressure should be kept between 6-8 bar to achieve reasonable energy consumption. It is recommended to install the air booster pump vertically to prevent aging and deformation of the sealing ring and piston rod caused by long-term disuse. During installation, follow the drawings provided by Taizhou Feentor to prevent damage to some components due to installation errors. When installing the air booster pump, try to keep it away from places with high dust. If it is not feasible, try to make a dust cover to increase the service life of the air booster pump.

Air booster pump

Precautions for maintenance:

Maintenance should be carried out when both the drive and low-pressure air intake are cut off. When purchasing a Taizhou Fuente air booster pump, a two in one unit will be included with the pump. The two in one unit will filter moisture and lubricate the pump. During maintenance, the water in the two in one unit should be drained and lubricating oil should be added. Pay attention to wiping the dust on the air booster pump, replacing the sealing ring on the reversing valve, cleaning the impurities inside the reversing valve, applying a layer of lubricating grease and reinstalling it in the original way. If possible, the boosting cylinder and driving cylinder can be cleaned and maintained like a reversing valve.

That's all for the knowledge about air booster pumps. If you have any further questions, please visit our website http://www.tz-fet.com/

The above content belongs to the copyright of Taizhou Feentor - Plagiarism will be prosecuted