Feentor Pneumatic Liquid Boosting Pump ZTGD Series Double Head High Flow Boosting Pump Details Introduction.

Feentor Pneumatic Liquid Boosting Pump ZTGD Series Double Head High Flow Boosting Pump Details Introduction.

Double head pneumatic liquid booster pump, also known as double acting booster pump, has high output pressure, strong automatic suction ability, automatic replenishment of consumption pressure, automatic stop after reaching pressure, can use multiple media for boosting, has a wide range of applications and simple maintenance, and is easy to operate. It is a modification of the Feentor ZTG series booster pump into a dual head pump, with a flow rate approximately 1.6 times that of the ZTG series pump.

The driving port of this series of pumps is G1/2, and the output pressure is equal to the driving air pressure multiplied by the boost ratio multiple. If the driving air pressure is 5 bar and the boost ratio is 100:1, then the output pressure is 5 * 100=500 bar=50 Mpa. If there is pressure in the inlet liquid, the output pressure should also be added to the inlet pressure.

The ZTGD series pneumatic liquid booster pump has a wide range of applications, especially for pressure testing and destructive testing of products. It can also be used as a permeability test for chemical reagents, replacing the original hydraulic pump station. In addition, the pump can be made into an integrated system as a core component, such as pneumatic booster system, blasting test bench, static pressure testing machine, pneumatic power unit, water pressure testing equipment, pulse fatigue testing bench, bolt and nut tensioner, high-pressure expansion tube equipment, high-pressure liquid filling equipment, etc.

When choosing a Feentor pump, it is important to pay attention to the driving pressure, which is the pressure that drives the device. What is the output pressure? It also requires the pressure output of the pump, so it is recommended to leave some margin in the selection. What are the requirements for traffic? Some customers say that liquids cannot be compressed and the flow rate does not matter. It is usually recommended that customers consider the compression time and product deformation rate. In addition, if the volume of the tested object is large, it is wise to fill it with water first.

The following are the parameters of the pneumatic liquid booster pump ZTGD