Application of Compressed Air Boosting System in Laser Cutting Machine Industry

Technical support inquiry / 2026-08-18 08:58:00 气动增压系统压缩空气增压系统

Pneumatic Boosting System - Application in Laser Cutting Machine Industry

The pneumatic boosting system - gas power unit is particularly suitable for adjusting the gas source pressure of cutting machines, which can increase and stabilize the gas source pressure of the supplied cutting machine at the normal operating pressure. Install it at the inlet of the cutting machine air source.

The blowing aperture of laser cutting machine is generally around 0.5mm-3mm. The cutting plate is usually metal plate, galvanized plate, aluminum plate, stainless steel plate, etc. It is also used for laser cutting;

The pneumatic boosting system increases the air pressure of the original air compressor by 2 or 5 times, and the output flow rate is generally required to be between 1m ³ and 1.5m ³, and the output pressure is generally between 1.0mpa and 1.5mpa;

Taking the 200W-1000W light cutting machine as an example, generally 1-2 Fuente pneumatic air booster pumps are required as the core components, plus one 80-200 liter air storage tank; Provide a cutting machine for use. The reason for adopting the Fuente compressed air boosting system is that it can greatly reduce the energy consumption of the factory. Generally, the air compressor in the factory is within 8 bar, but it cannot meet the pressure requirements of the laser cutting machine. In this case, if the Feentor brand pneumatic boosting system is used, it can better meet the local boosting requirements of customers;

Laser cutting machine customers also use nitrogen cylinders or liquid nitrogen for decompression, but the consumption of nitrogen cylinders is too high, resulting in excessive costs for the company. In this case, the appearance of the Feentor ZTS-ZTV02F compressor air pressurization system solves the problem of capital waste for many customers.

Core component ZTS-ZTV02F parameters

traffic	1360L/min
Output Pressure	20bar
Boost ratio	2.5:1
gas storage tank	40-100升
Installation method	卧式安装
Drive air pressure	3-8bar
Low pressure inlet	G1
Drive port	G1
High pressure outlet	G1