High flow gas booster pump

    High flow gas booster pump


    The application of gas booster pumps in industry is increasing, and there are more and more ways for customers to use them on site. Gas booster pumps for local boosting, especially those with high flow rates, are becoming more and more widely accepted by customers


    The parameters of the high flow gas booster pump are as follows


    Model: ZTS-ZTA02


    Flow rate: 1m ³/min


    Gas storage tank: 40-100L


    Pressure: 0-20bar


    Boost ratio: 2:1


    Typical application of high flow gas booster pump


    (1) Continuous purging of impurities and nitrogen protection with 15 bar gas in the laser cutting industry


    (2) Spray coating on kitchenware, using 8 bar air assisted spray coating


    (3) The airbag is used to replenish air and maintain pressure, and the pressure requirement is constant without dropping


    (4) Rapid inflation inside the high-pressure gas cylinder requires a pressure of 20 bar


    (5) Automobile repair and replacement factories require pneumatic wrenches and tools to provide 10 bar air pressure


    (6) Low pressure gas spring internal inflation and lifting chair internal gas inflation


    The characteristics of a high flow gas booster pump are


    (1) The pressure can be adjusted from 0 to 20 bar, and the flow rate is related to the inlet pressure and can reach 1.36m ³/min


    (2) Pressure can be freely adjusted and controlled


    (3) The high-pressure outlet is equipped with a pressure reducing valve for easy pressure control


    (4) Low equipment maintenance rate and simple maintenance


    (5) Gas storage tank with pressure vessel certificate


    (6) Configuring pressure relief valves to further ensure reliable use


    (7) No sparks, explosion-proof


    Typical circuit diagram of high flow gas booster pump


    High flow gas booster pump

    The above content belongs to the copyright of Taizhou Feentor - Plagiarism will be prosecuted

     

    本站使用百度智能门户搭建 管理登录