Typical case analysis of technical requirements for compressed air booster pump device.

Technical requirements for compressed air booster pump device

A certain testing center needs to purchase a compressed air booster to increase the compressed air pressure in the testing center. This turbocharger is powered by consuming compressed air and compresses it to a specified pressure. When the compressed air pressure in the gas system is lower than the specified pressure, it will automatically start, and when it reaches the specified pressure, it will automatically stop.

1、 Equipment specifications and quantity:

二、供货范围及设备配置：

3、 Technical requirements for compressed air booster pump device:

3.1. Gas pressure: 1.0Mpa;

3.2. Exhaust volume: 1.5m3/min;

3.3. Front end input air source: 0.8Mpa, oil-free compressed air, dew point temperature: -40 ℃;

3.4 Turbocharger: ratio 1:2, maximum output pressure 1.6Mpa, flow rate 500-1600L/min;

3.5. Gas storage tank: 2.5MPa, ø 1200 × 3000, made of carbon steel, equipped with a safety valve that meets the requirements of the pressure vessel supervision regulations; Provide a complete set of pressure vessel documentation that meets the requirements of the pressure vessel supervision regulations, including quality certificates, factory certificates, formal drawings, etc;

3.6. Gas supply pressure control: can be manually switched, equipped with a filter, air separation block, pressure regulating range: 0.6-1.6Mpa, flow rate 4000L/min;

3.7. Install pressure gauges at the inlet, outlet, and storage tank of the turbocharger.

4、 Quality standards:

4.1. The scope of supply, configuration, and performance shall meet the contract requirements, and complete equipment information shall be provided: factory certificate of conformity, pressure vessel information, user manual, maintenance and repair manual, list of vulnerable parts, etc;

4.2 Warranty period: 1 year

5、 Debugging and acceptance:

5.1. Party A is responsible for equipment installation and shall notify Party B to carry out equipment debugging when the debugging conditions are met (Party B is responsible for equipment debugging and Party A cooperates);

5.2 If the equipment runs for 30 days without any faults and meets the quality standards, the equipment acceptance shall be carried out.

5、 The sketch of the compressed air booster pump device is as follows

Compressed air booster pump