How to deal with insufficient filling amount of carbon dioxide booster pump during the filling process?

How to deal with insufficient filling amount of carbon dioxide booster pump during the filling process?

At present, many customers use pneumatic CO2 filling and pressurization systems in the filling process of some small steel cylinders. However, during the filling process, it may be found that some small cylinders are sometimes filled, and sometimes it is difficult to reach the filling weight. Below, the editor will analyze how to deal with the appeal phenomenon in response to this phenomenon.

Firstly, it is necessary to clarify the source of one's carbon dioxide medium? Only by identifying the source of carbon dioxide can there be no errors in the initial selection of cold tank tanks and steel cylinders.

2. The filled carbon dioxide small bottle is usually measured by weight, for example, filling an 8g small bottle, as well as 1.5kg, 3.2kg, and 4kg; It is judged by weight whether it is full or not. The commonly used CO2 filling pump is mainly liquid carbon dioxide.

During the filling process, changes in temperature and inlet medium can cause difficulty in increasing the pressure of carbon dioxide, or an increase in temperature can lead to an increase in the internal pressure of the filled bottle, causing the pump drive to balance with the output pressure and stop working.

So how to deal with the appeal situation?

When filling steel cylinders with a carbon dioxide booster pump, it is recommended to use the initial cylinder to ensure that as much liquid CO2 as possible is filled and pressurized. In addition, the filled small bottle should be depressurized and placed in a low-temperature environment to prevent vaporization.

2. The area where the medium comes into contact should be insulated to prevent the increase in ambient temperature from causing a decrease in boost flow rate.

If the filled steel cylinder is found to be insufficient and the pump has stopped working normally, it is recommended to release some gas pressure at the connection port of the steel cylinder before filling.

In fact, when the carbon dioxide booster pump is working, it only needs to pay attention to the correct selection, and the working conditions must be reported to the sales engineering. Based on the experience and suggestions of Feentor manufacturer, it can definitely make your filling process no longer blocked!

CO2 pressurization equipment